Fire Sense 61541 Manual de instrucciones descargar pdf (Pagina 16)

WARNING

FOR YOUR SAFETY

Heater will be hot after use

Handle with extreme care

3.3 LIGHTING

1. Push control knob IN and turn to OFF.

2. Turn the gas tank valve ON.

3. Depress the burner control knob and turn it (anticlockwise) to the igniting position.

4. Press the piezo-ignition concurrently with your other hand and hold the pressed knob

for about 10 seconds after ignition in order to activate the ignition safety switch. Should

the gas fail to ignite after pressing the piezo-ignition 3 or 4 times, leave the appliance

for about 5 minutes that any gas to clear and then repeat the process.

Note:

It is possible to ignite the burner using other ignition devices

(gas lighters, matches) through the 0.73 inch aperture in the bottom of the burner.

Caution:

Avoid inhaling fumes emitted from the heater‘s rst use. Smoke and odour from the

burning of oils used in manufacturing will appear. Both smoke and odor will dissipate

after approximately 30 minutes. The heater should NOT produce thick black smoke.

Note:

The burner may be noisy when initially turned on. To eliminate excessive noise from the

burner, turn the Control Knob to the small ame position. Then, turn the knob to the

level of heat desired.

3.4 WHEN HEATER IS ”ON”

Emitter screen will become bright red due to intense heat. The colour is more visible at

night. Burner will display tongues of blue and yellow ame. These ames should not be

yellow or produce thick black smoke, indicating an obstruction of airow through the

burners. The ame should be blue with straight yellow tops.

3.5 RE-LIGHTING

Turn Control Knob to 0FF

Wait at least 5 minutes, to let gas dissipate, before attempting to relight.

Repeat the “Lighting“ steps on prior page.

3.6 SHUTDOWN

1. Turn the burner control knob clockwise to the igniting position.

2. Depress the control knob and turn it clockwise to OFF.

3. Turn tank valve clockwise to OFF. Disconnect the regulator when heater is not in use.

Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the

type of dust cap on the cylinder valve outlet that is provided by the cylinder valve. Other

types of caps or plugs may result in leakage of propane.

WARNING

FOR YOUR SAFETY

Be careful when

attempting to manually

ignite this heater.

Holding in the control

knob for more than 5

seconds before igniting

the gas will cause a ball

ofameuponignition.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Fire Sense 61541 Manual de instrucciones Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Calentadores espaciales Fire Sense 61541